- 1. In a Cisco router, the primary interface used for its initial configuration would be its _______________________ interface.
A) Serial
B) AUX
C) console
D) Ethernet
- 2. A reason why fiber would be preferable over copper cabling would be that with fiber offers _________________ distances of data transfer can be obtained per cable run.
A) distinct
B) equal
C) lesser
D) greater
- 3. A reason why fiber would be preferable over copper cabling would be that with fiber is ____________ susceptible to Electro-magnetic interference.
A) less
B) equally
C) distinctly
D) more
- 4. You are advised you are on a limited budget, your cabling distances are limited and you cannot purchase repeaters. Would type of cabling would you use?
A) single-mode fiber
B) STP
C) multi-mode fiber
D) UTP
- 5. Attenuation occurs in data transfers which use longer cabling that what ANSI specifies. Attenuation in other words is the loss of signal strength as the ________________ increases.
A) distance
B) servers
C) domains
D) fast-Ethernet ports
- 6. You are given the IP 130.68.0.0 with a subnet mask of 255.255.248.0. How many host addresses do you have per subnet?
A) 30
B) 4094
C) 2046
D) 4
- 7. What type of network cable would you use between a terminal and a console port?
A) rollover
B) patch over
C) CAT 1000E
D) cross-over
- 8. Which device would you use to create or divide broadcast domains?
A) switch
B) hub
C) bridge
D) gateway
- 9. The 3 types of connectors usually seen with Cisco's v.35 serial cables are the DB 60, Winchester 15 pin, and the ______ _______.
A) DB 609
B) RJ 45
C) RJ 11
D) smart serial
- 10. A common method for setting up a UTP Ethernet port to MDI or MDIX operation is to follow the cable color ________ association.
A) 568A and 568B
B) code
C) serialization
D) cabling
- 11. Routers are able to segment (partition) broadcast _________________.
A) collisions
B) technologies
C) domains
D) servers
- 12. Routers are able to interconnect different ________________ technologies.
A) server
B) Microsoft
C) switching
D) network
- 13. Each interface on a router require a separate network or ________________.
A) server
B) subnet
C) domain
D) switch
- 14. To establish a console connection from a PC to a CISCO router, which cable wiring option would you use?
A) straight-through copper cable
B) V.35 supersized thin-net cable
C) cross-over copper cable
D) rollover cable
- 15. Cabling that extended from one telecommunications room to another, would tend to be __________________ cabling.
A) transversal
B) acute
C) vertical
D) horizontal
- 16. Cabling that extended from the telecommunications room to the work area, would tend to be _____________________ cabling.
A) vertical
B) horizontal
C) acute
D) transversal
- 17. At a work area, you would tend to find what type of cabling?
A) segmented
B) plenum-rated
C) patch
D) vertical
|