- 1. In a Cisco router, the primary interface used for its initial configuration would be its _______________________ interface.
A) console
B) AUX
C) Ethernet
D) Serial
- 2. A reason why fiber would be preferable over copper cabling would be that with fiber offers _________________ distances of data transfer can be obtained per cable run.
A) equal
B) distinct
C) greater
D) lesser
- 3. A reason why fiber would be preferable over copper cabling would be that with fiber is ____________ susceptible to Electro-magnetic interference.
A) equally
B) more
C) less
D) distinctly
- 4. You are advised you are on a limited budget, your cabling distances are limited and you cannot purchase repeaters. Would type of cabling would you use?
A) single-mode fiber
B) STP
C) UTP
D) multi-mode fiber
- 5. Attenuation occurs in data transfers which use longer cabling that what ANSI specifies. Attenuation in other words is the loss of signal strength as the ________________ increases.
A) fast-Ethernet ports
B) distance
C) servers
D) domains
- 6. You are given the IP 130.68.0.0 with a subnet mask of 255.255.248.0. How many host addresses do you have per subnet?
A) 2046
B) 4094
C) 30
D) 4
- 7. What type of network cable would you use between a terminal and a console port?
A) rollover
B) CAT 1000E
C) cross-over
D) patch over
- 8. Which device would you use to create or divide broadcast domains?
A) hub
B) gateway
C) bridge
D) switch
- 9. The 3 types of connectors usually seen with Cisco's v.35 serial cables are the DB 60, Winchester 15 pin, and the ______ _______.
A) DB 609
B) RJ 11
C) smart serial
D) RJ 45
- 10. A common method for setting up a UTP Ethernet port to MDI or MDIX operation is to follow the cable color ________ association.
A) code
B) cabling
C) 568A and 568B
D) serialization
- 11. Routers are able to segment (partition) broadcast _________________.
A) servers
B) collisions
C) technologies
D) domains
- 12. Routers are able to interconnect different ________________ technologies.
A) network
B) switching
C) Microsoft
D) server
- 13. Each interface on a router require a separate network or ________________.
A) server
B) subnet
C) switch
D) domain
- 14. To establish a console connection from a PC to a CISCO router, which cable wiring option would you use?
A) V.35 supersized thin-net cable
B) cross-over copper cable
C) rollover cable
D) straight-through copper cable
- 15. Cabling that extended from one telecommunications room to another, would tend to be __________________ cabling.
A) horizontal
B) acute
C) vertical
D) transversal
- 16. Cabling that extended from the telecommunications room to the work area, would tend to be _____________________ cabling.
A) transversal
B) acute
C) vertical
D) horizontal
- 17. At a work area, you would tend to find what type of cabling?
A) plenum-rated
B) segmented
C) vertical
D) patch
|