- 1. In a Cisco router, the primary interface used for its initial configuration would be its _______________________ interface.
A) AUX B) console C) Ethernet D) Serial
- 2. A reason why fiber would be preferable over copper cabling would be that with fiber offers _________________ distances of data transfer can be obtained per cable run.
A) greater B) distinct C) lesser D) equal
- 3. A reason why fiber would be preferable over copper cabling would be that with fiber is ____________ susceptible to Electro-magnetic interference.
A) more B) less C) distinctly D) equally
- 4. You are advised you are on a limited budget, your cabling distances are limited and you cannot purchase repeaters. Would type of cabling would you use?
A) STP B) multi-mode fiber C) UTP D) single-mode fiber
- 5. Attenuation occurs in data transfers which use longer cabling that what ANSI specifies. Attenuation in other words is the loss of signal strength as the ________________ increases.
A) fast-Ethernet ports B) domains C) distance D) servers
- 6. You are given the IP 130.68.0.0 with a subnet mask of 255.255.248.0. How many host addresses do you have per subnet?
A) 4 B) 30 C) 4094 D) 2046
- 7. What type of network cable would you use between a terminal and a console port?
A) patch over B) CAT 1000E C) cross-over D) rollover
- 8. Which device would you use to create or divide broadcast domains?
A) bridge B) switch C) hub D) gateway
- 9. The 3 types of connectors usually seen with Cisco's v.35 serial cables are the DB 60, Winchester 15 pin, and the ______ _______.
A) smart serial B) DB 609 C) RJ 45 D) RJ 11
- 10. A common method for setting up a UTP Ethernet port to MDI or MDIX operation is to follow the cable color ________ association.
A) code B) 568A and 568B C) cabling D) serialization
- 11. Routers are able to segment (partition) broadcast _________________.
A) technologies B) collisions C) servers D) domains
- 12. Routers are able to interconnect different ________________ technologies.
A) switching B) network C) server D) Microsoft
- 13. Each interface on a router require a separate network or ________________.
A) subnet B) server C) domain D) switch
- 14. To establish a console connection from a PC to a CISCO router, which cable wiring option would you use?
A) cross-over copper cable B) rollover cable C) V.35 supersized thin-net cable D) straight-through copper cable
- 15. Cabling that extended from one telecommunications room to another, would tend to be __________________ cabling.
A) horizontal B) vertical C) acute D) transversal
- 16. Cabling that extended from the telecommunications room to the work area, would tend to be _____________________ cabling.
A) vertical B) horizontal C) acute D) transversal
- 17. At a work area, you would tend to find what type of cabling?
A) patch B) segmented C) vertical D) plenum-rated
|