CCNA Semester 1 - Chapter 10B
- 1. In a Cisco router, the primary interface used for its initial configuration would be its _______________________ interface.
A) Ethernet
B) AUX
C) console
D) Serial
- 2. A reason why fiber would be preferable over copper cabling would be that with fiber offers _________________ distances of data transfer can be obtained per cable run.
A) equal
B) lesser
C) greater
D) distinct
- 3. A reason why fiber would be preferable over copper cabling would be that with fiber is ____________ susceptible to Electro-magnetic interference.
A) less
B) equally
C) more
D) distinctly
- 4. You are advised you are on a limited budget, your cabling distances are limited and you cannot purchase repeaters. Would type of cabling would you use?
A) multi-mode fiber
B) STP
C) single-mode fiber
D) UTP
- 5. Attenuation occurs in data transfers which use longer cabling that what ANSI specifies. Attenuation in other words is the loss of signal strength as the ________________ increases.
A) fast-Ethernet ports
B) servers
C) distance
D) domains
- 6. You are given the IP 130.68.0.0 with a subnet mask of 255.255.248.0. How many host addresses do you have per subnet?
A) 4
B) 2046
C) 30
D) 4094
- 7. What type of network cable would you use between a terminal and a console port?
A) patch over
B) rollover
C) cross-over
D) CAT 1000E
- 8. Which device would you use to create or divide broadcast domains?
A) gateway
B) bridge
C) hub
D) switch
- 9. The 3 types of connectors usually seen with Cisco's v.35 serial cables are the DB 60, Winchester 15 pin, and the ______ _______.
A) DB 609
B) RJ 45
C) RJ 11
D) smart serial
- 10. A common method for setting up a UTP Ethernet port to MDI or MDIX operation is to follow the cable color ________ association.
A) cabling
B) 568A and 568B
C) code
D) serialization
- 11. Routers are able to segment (partition) broadcast _________________.
A) technologies
B) domains
C) collisions
D) servers
- 12. Routers are able to interconnect different ________________ technologies.
A) Microsoft
B) network
C) server
D) switching
- 13. Each interface on a router require a separate network or ________________.
A) switch
B) domain
C) subnet
D) server
- 14. To establish a console connection from a PC to a CISCO router, which cable wiring option would you use?
A) straight-through copper cable
B) V.35 supersized thin-net cable
C) cross-over copper cable
D) rollover cable
- 15. Cabling that extended from one telecommunications room to another, would tend to be __________________ cabling.
A) horizontal
B) acute
C) transversal
D) vertical
- 16. Cabling that extended from the telecommunications room to the work area, would tend to be _____________________ cabling.
A) transversal
B) horizontal
C) vertical
D) acute
- 17. At a work area, you would tend to find what type of cabling?
A) vertical
B) plenum-rated
C) patch
D) segmented
|
Učenci, ki so rešili ta test so rešili tudi :