- 1. Which tool was used to Mark lines at 90 degrees (Right angle) to the edge of the wood?
A) Tri-Square
B) Steel Rule
C) Marking Gauge
- 2. What kind of saw is tool “D” ?
A) Mitre Saw
B) Cross Cut Saw
C) Hack Saw
D) Tenon Saw
- 3. Which tool did you use to measure the sizes of the joints?
A) Steel Rule
B) Marking Gauge
C) Tri-Square
D) Protractor
- 4. Name the tool we used “E” to support the wood while sawing.
A) Block Board
B) Holding Bracket
C) Vice Guard
D) Bench Hook
- 5. Which tool was best suited for marking lines parallel to the edge of the wood?
A) Steel Rule
B) Scriber
C) Marking Gauge
D) Tri-Square
- 6. Tool “F” was used to remove scrap wood from our joints. What is it called?
A) Hand Scraper
B) Rough Cut File
C) Mortise Gauge
D) Bevel Edged chisel
- 7. We used this tool to chamfer some of the clock parts. What is it called?
A) Router
B) Finisher
C) Jack Plane
D) Smoother
- 8. We used this Glue to assemble the clock. What type of glue is it?
A) Epoxy Resin
B) Contact Adhesive
C) P.V.A.
D) Super Glue
- 9. We finished a few parts of our clock on the Band facer.. Give a safety rule that we used here.
A) Wear safety gloves
B) Goggles were worn.
C) Hard hat required.
D) Keep away from water.
- 10. When we were cutting our joints as shown in the photo, what safety rule were we folhighing?
A) Must wear safety goggles.
B) Strike the chisel heavily.
C) Both hands behind the cutting edge of the chisel.
D) Use a heavy mallet.
|