- 1. In a Cisco router, the primary interface used for its initial configuration would be its _______________________ interface.
A) console B) Serial C) Ethernet D) AUX
- 2. A reason why fiber would be preferable over copper cabling would be that with fiber offers _________________ distances of data transfer can be obtained per cable run.
A) greater B) distinct C) lesser D) equal
- 3. A reason why fiber would be preferable over copper cabling would be that with fiber is ____________ susceptible to Electro-magnetic interference.
A) less B) distinctly C) equally D) more
- 4. You are advised you are on a limited budget, your cabling distances are limited and you cannot purchase repeaters. Would type of cabling would you use?
A) single-mode fiber B) UTP C) STP D) multi-mode fiber
- 5. Attenuation occurs in data transfers which use longer cabling that what ANSI specifies. Attenuation in other words is the loss of signal strength as the ________________ increases.
A) servers B) fast-Ethernet ports C) domains D) distance
- 6. You are given the IP 130.68.0.0 with a subnet mask of 255.255.248.0. How many host addresses do you have per subnet?
A) 2046 B) 4 C) 30 D) 4094
- 7. What type of network cable would you use between a terminal and a console port?
A) rollover B) CAT 1000E C) cross-over D) patch over
- 8. Which device would you use to create or divide broadcast domains?
A) gateway B) bridge C) switch D) hub
- 9. The 3 types of connectors usually seen with Cisco's v.35 serial cables are the DB 60, Winchester 15 pin, and the ______ _______.
A) smart serial B) RJ 45 C) DB 609 D) RJ 11
- 10. A common method for setting up a UTP Ethernet port to MDI or MDIX operation is to follow the cable color ________ association.
A) serialization B) 568A and 568B C) cabling D) code
- 11. Routers are able to segment (partition) broadcast _________________.
A) technologies B) servers C) domains D) collisions
- 12. Routers are able to interconnect different ________________ technologies.
A) switching B) server C) Microsoft D) network
- 13. Each interface on a router require a separate network or ________________.
A) switch B) subnet C) server D) domain
- 14. To establish a console connection from a PC to a CISCO router, which cable wiring option would you use?
A) straight-through copper cable B) V.35 supersized thin-net cable C) rollover cable D) cross-over copper cable
- 15. Cabling that extended from one telecommunications room to another, would tend to be __________________ cabling.
A) horizontal B) transversal C) acute D) vertical
- 16. Cabling that extended from the telecommunications room to the work area, would tend to be _____________________ cabling.
A) acute B) vertical C) horizontal D) transversal
- 17. At a work area, you would tend to find what type of cabling?
A) vertical B) patch C) plenum-rated D) segmented
|