- 1. 1. The following are major components of lathe machines
A) Headstock
B) Carriage
C) Wool
D) Tailstock
- 2. 2. Which of the following is not in the category of operations that are commonly performed on the lathe machines?
A) Steaming
B) Facing
C) Cutting
D) Turning
- 3. 3. The operation that is used to produce flat surfaces on lathe machines is called ----------
A) Facing
B) Drilling
C) Turning
D) Knurling
- 4. 4. An operation which involves cutting threads on a workpiece is known as --------
A) Pain cutting
B) Lateral cutting
C) Deep cutting
D) Screw cutting
- 5. 5. Which of the following machines is most suitable for marking holes in a workpiece?
A) Mill press
B) Air press
C) Forge press
D) Drill press
- 6. 6. The following are types of grinding machines except ----------
A) Surface grinder
B) Bench grinder
C) Plain grinder
D) Belt grinder
- 7. 7. The coolant which helps to reduce distortion, power consumption, improve surface finish and protects against corrosion of the workpiece is called ----
A) Sprinkler fluids
B) Cutting fluid
C) Milling gas
D) Grinding powder
- 8. 8. The machine that can be used to cut workpieces with coarse tooth hacksaw blades is called ------
A) Screw machine
B) Chamfering machine
C) Turning machine
D) Power sawing machine
- 9. 9. Forging can be classified into the following except.....
A) Hot forging
B) Warm forging
C) Cloudy forging
D) Cold forging
- 10. 10. The types of folding machines include the following except -----
A) Knife folder
B) Knot folder
C) Buckle folder
D) Paper folder
- 11. 11. The series of operations that transform industrial materials from a raw material state into a finished product state is called
A) Quarter sawn
B) Feller bunching
C) Material processing
D) Pre-cut
- 12. 12. The key concept of timber processing includes the following except -------
A) Conversion
B) Seasoning
C) Treatability
D) Growth and felling
- 13. 13. One of the following is not a process in timber felling.
A) Limbing
B) Knitting
C) Bucking
D) Skidding
- 14. 14. ------ and ------ are the two methods of timber seasoning
A) Natural and artificial seasoning
B) Limbing and bucking seasoning
C) Plain and quarter seasoning
D) Limbing and skidding seasoning
- 15. 15. In the conversion of timber, the method that produces radial boards and far more expensive than the tangential timber because of the need to double handle the log is known as --------
A) Plain and edge sawn
B) Quarter sawn
C) Through and through sawn
D) Curved sawn
- 16. 16. Drying process that involves the introduction of heat is ------
A) Solar Energy drying
B) Temperate drying
C) Hot drying
D) Kiln drying
- 17. 17. The most common treatment process is known as -----
A) Temple treatment
B) Pressure treatment
C) Temperature treatment
D) Deliberate treatment
- 18. 18. One of the following is not a preservative for timber.
A) Light organic solvent-borne preservatives
B) waterborne preservatives
C) Envelope treatment
D) Folder treatment
- 19. 19. Defects due to insects and other animals include the following except ----------
A) Warping
B) Birds and mammals
C) Marine borer
D) Insects
- 20. 20. One of the following is not a defect due to conversion.
A) Machine notches
B) Boxed heart
C) Case hardening
D) Miscut
|