- 1. Which tool was used to Mark lines at 90 degrees (Right angle) to the edge of the wood?
A) Tri-Square
B) Marking Gauge
C) Steel Rule
- 2. What kind of saw is tool “D” ?
A) Tenon Saw
B) Mitre Saw
C) Cross Cut Saw
D) Hack Saw
- 3. Which tool did you use to measure the sizes of the joints?
A) Steel Rule
B) Tri-Square
C) Protractor
D) Marking Gauge
- 4. Name the tool we used “E” to support the wood while sawing.
A) Block Board
B) Bench Hook
C) Holding Bracket
D) Vice Guard
- 5. Which tool was best suited for marking lines parallel to the edge of the wood?
A) Scriber
B) Tri-Square
C) Steel Rule
D) Marking Gauge
- 6. Tool “F” was used to remove scrap wood from our joints. What is it called?
A) Rough Cut File
B) Mortise Gauge
C) Bevel Edged chisel
D) Hand Scraper
- 7. We used this tool to chamfer some of the clock parts. What is it called?
A) Jack Plane
B) Router
C) Smoother
D) Finisher
- 8. We used this Glue to assemble the clock. What type of glue is it?
A) P.V.A.
B) Contact Adhesive
C) Epoxy Resin
D) Super Glue
- 9. We finished a few parts of our clock on the Band facer.. Give a safety rule that we used here.
A) Wear safety gloves
B) Hard hat required.
C) Keep away from water.
D) Goggles were worn.
- 10. When we were cutting our joints as shown in the photo, what safety rule were we folhighing?
A) Use a heavy mallet.
B) Both hands behind the cutting edge of the chisel.
C) Must wear safety goggles.
D) Strike the chisel heavily.
|