Dremel 3D 20 Test: Glossary of Terms
| __ | 1. | Build Platform | | A. | Located at the front of the platform to secure it in place | | __ | 2. | Build Platform Clip | | B. | The flat surface used by your Dremel to build objects | | __ | 3. | Build Tape | | C. | Helps objects stick to the build plate | | __ | 4. | Build Volume | | D. | Located on the top to allow access to the Dremel | | __ | 5. | Door | | E. | 3D space an object takes up once it is built | | __ | 6. | Extruder | | F. | Located on the front panel to allow access inside the Dremel | | __ | 7. | Extruder fan | | G. | Uses gears and heat to push filament out | | __ | 8. | Extruder Intake | | H. | Stops the extruder at the end of travel | | __ | 9. | Lid | | I. | Where filament is inserted for builds | | __ | 10. | Limit Switch | | J. | Cools the extruder and outer assembly |
| __ | 11. | Extruder Push Lever | | A. | Used to loosen the grip of the extruder gear motor | | __ | 12. | Extruder Tip | | B. | Nozzel where filament is pushed out | | __ | 13. | Filament | | C. | Threadlike spool of plastic material | | __ | 14. | Filament Guide Tube | | D. | Piece that filament is wound and stored for use | | __ | 15. | Filament Spool | | E. | Common tool used to remove small objects | | __ | 16. | Leveling Knobs | | F. | Made from corn starch | | __ | 17. | Leveling Tool | | G. | Guides filament spool | | __ | 18. | Needle Nose Pliers | | H. | Located under the platform used for spacing | | __ | 19. | Object Removal Tool | | I. | Pad with markings and directions for use | | __ | 20. | PLA | | J. | Used to separate objects from the build platform |
| __ | 21. | .3Dremel File | | A. | Common 3D file format | | __ | 22. | .G3Drem File | | B. | Portable memory card | | __ | 23. | .STL File | | C. | Locks the filament spool to the spool holder | | __ | 24. | SD Card | | D. | Dremel digital file format | | __ | 25. | Spool Lock | | E. | File format compatible with Dremel | | __ | 26. | Touch Screen | | F. | Color display that is touch activated | | __ | 27. | Unclog Tool | | G. | Used to clear the extruder from debris | | __ | 28. | X-Axis Guide rails | | H. | Moves the extruder left and right | | __ | 29. | Y-Axis Guide rails | | I. | Moves the extruder front and back | | __ | 30. | Z-Axis Guide rails | | J. | Moves the extruder up and down |
|
Students who took this test also took :